Materials:

1 24MM silver circle

12 37 X 32MM silver fish

Fine silver colored wire or fishing line

27 25MM fish shaped pony beads

27 8MM round beads or dangles

Instructions:

Lay out the parts as shown in the picture. Make a hanger loop for the top of the round disk. Thread a piece of wire through the bottom of each of the three holes, making sure they are staggered, but close enough in length so the fish you will add will clink together.

Place the wire through the top hole in each fish. Twist the wire ends together and trim. Repeat for the other fish.

Place a fish shaped pony bead through some of the bottom fish holes (following the placement in the picture). Put the wire through the hole, through the pony bead and through the round bead or dangle, then bring the wire back up through the pony bead, twist the ends together and trim.

Repeat the above instructions for the remaining supplies to finish your wind chime. You may use more or less beads and fish to make the chime longer or shorter. The final row of fish will be completed with the pony beads and round beads or dangles.

Resource:Supplies available through Sunshine Crafts or your local craft store.